Guy
D-LINK DE220 series cards are plug and play so should all ready be seen by
Linux. ( dependant on version)
You can see if this is so by typing the following line a see if there is any
reference to it
dmesg | more
if that doesn't work you can boot a dos disk and run setup and take it out
of plug and play mode I have sent you an email with both dos driver and
manual attached
Paul
----- Original Message -----
From: "Guangyue Liu" <gxl00u@Cs.Nott.AC.UK>
To: <nottingham@lists.lug.org.uk>
Cc: <gxl00u@Cs.Nott.AC.UK>
Sent: Monday, April 01, 2002 2:40 AM
Subject: [nottingham] io and irq
> Hi guys,
>
> hope you all having a nice easter break, unlike me...
>
> I'm trying to configure an ISA network card, (D-LINK DE220 PCT) and i'm
pretty
> damn sure that it is ne compatible (or is it?). But apparently i'll need
to
> specify io=0xNNN and irq=blah when doing insmod or it wont work. (or is
that
> so?) just wondering how i can find out these values, i've tried playing
around
> in the BIOS, looking at the boot messages and eating a lot of eater eggs.
> However none of them could solve the problem. so please help.
>
> cheers
>
> Guy
> ps. by the way mike, i'm on the list as well, as u've probably noticed
>
> --------------------------------------------------------------------
> http://www.lug.org.uk http://www.linuxportal.co.uk
> http://www.linuxjob.co.uk http://www.linuxshop.co.uk
> --------------------------------------------------------------------
--------------------------------------------------------------------
http://www.lug.org.uk http://www.linuxportal.co.uk
http://www.linuxjob.co.uk http://www.linuxshop.co.uk
--------------------------------------------------------------------
This archive was generated by hypermail 2.1.3 : Mon 01 Apr 2002 - 02:51:50 BST